Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don’t
change the page numbering. Keep the language
integrity.
18
/
48
Assembly page 18/48
Fax +32 030 9904733
ventilation, signal lamp and will switch off. The knob will turn gradually towards
the "0" position, and when it reaches "0", a buzzer sounds.
-
Internal Convention:
the hot air circulates in the oven cavity to brown and
cook evenly, is active when the timer is on.
The oven is provided also with the following accessories:
-
Tong to remove rack and plate (1)
-
shelf grid (7) that can be placed in one of the slots provided, removing the
shelf grid by using the appropriate handle
-
baking tray (8) that can be placed in one of the slots provided, removing the
baking pan by using the appropriate handle
-
enamel tray (9) is properly attached underneath the lower heating element
to prevent the surface under the oven from overheating.
-
Pilot light: is on when the timer function
When using for the first time
1.
Before each use, verify that the unit is in good condition, the electric cord is
not damaged, if the power cord is damaged, it must be replaced by the
manufacturer or a competent qualified electrician or a person with similar
qualifications, in order to avoid any risk.
2.
Attention:
before cleaning the appliance, remove the plug from the outlet.
3.
When using for the first time, wash the rack, baking plate and crumb tray and
dry them carefully before use. Before each use, check that the equipment is
in good condition in all its parts, if it is not, or if in doubt do not use it and
have it checked by qualified personnel.
4.
Before being used for cooking, the appliance should be switched on “empty”
to eliminate the “smell of new” and any oils remaining from the production
process. Insert the plug in the power socket, turn thermostat to “max”, turn
the timer knob to position “20”, position the selector knob
. When the
cycle ends, remove the plug from the socket and wait until the appliance is
cool before removing the accessories.
Using the oven
Generally speaking it is not necessary to preheat the oven, but for some foods
(meat, pastries) it is advisable to preheat the oven as described above, making
sure the door is closed properly.
Put the shelf grids or/and enamel baking tray at the desired height in the slots in
the oven.
•
Place the enamel tray at the bottom of the oven.
•
Put the food (in the plate or baking tray, etc.) and shut the door.
•
Follow these instructions:
-
Insert the plug in the power socket
-
Turn the thermostat knob clockwise to the temperature required
-
Turn the selector switch to desiderate position
-
Turn the timer knob to the time required: the pilot light and inside lamp
come on and the oven starts to heat: if cooking time is not sufficient,
restart the timer for the time still required.
•
When cooking is completed, turn the thermostat to pos. min (100) and
remove the plug from the power socket.
Attention: Never leave the appliance connected to the socket if it is not
in use or before cleaning.
