Binatone FBM-311, Instruction Manual

6

USER INSTRUCTION

Use of the appliance

1. Install the appliance on a flat horizontal sur-

face in front of a comfortable seat (chair).

2. Fill the massage appliance with water of re-

quired temperature to the maximum level.

To enhance the effect of the massage, you

may add salt (preliminary dissolved in a small amount of water)
or bath oil to water.

3. Connect the appliance to electric mains.
4. Sit down and put down feet in bath. 

Always put in and take

out feet from the bath in whilst in sitting position.

5. Set the switch of operation mode 

(3)

 in required position.

6. For more intense foot massage, install massage rollers 

(7)

 on the

surface for acupunctural massage 

(5)

, as shown in the figure.

7. After massage procedures, set the switch 

(3)

 in position «0» and

follow instructions in the section «Maintenance».

Description of operation modes

of the appliance

Heating

Massage appliance heats water to 40

o

C, irrespective of its

starting temperature. Hence, you can fill it with cold water. In this
case, that heating the water will take time.

Infrared radiation

Infrared radiation improves circulation in legs and relieves mus-

cular stress. Infrared radiation leads to fast cell renewal. It has an
anti-inflammatory and analgesic effect.

Vibration massage with infrared radiation

Vibration massage relives muscular stress and improves circu-

lation. Vibration massage can be used both with and without filling
the appliance with water. Combination of infrared radiation and
massage gives a very good therapeutic effect.

Note

: time of vibration massage without water should not

exceed 10 minutes, with water – 20 minutes.

Hydromassage with heating

The combined effect of warm water and hydromassage gives

the sensation of being touched and you will feel a calming effect

BEFORE USE

Remove all package materials from the appli-
ance.