KBF-LQC (E5.2) 12/2010
page 25/106
4.2
Wastewater connection
Fasten the wastewater hose to the waste-water connection “OUT” (18) on the rear of the unit (olive
∅
14
mm). Observe the following points:
•
You can use a part of the delivered water hose as a drainage hose. In case another hose is used, it
has to be permanently resistant against at least 95 °C /
203°F
.
•
Mount the wastewater hose with a maximum positive inclination of 1 m and a maximum total length of
3 m.
•
Protect both ends of the drainage hose with two of the four delivered hose clamps.
Waste water is collected in an internal can with a volume of approx. 0.5 liters. It is pumped off
only when required, thus there is no continuous waste water flow.
(15)
(18) (17)
(15) Power
cable
(16) not
used
(17) Freshwater connection “IN” with screw
thread ¾’’ for hose ½“, with union nut
(18) Waste-water connection “OUT” with hose
olive for hose ½“
Figure 11: Rear view KBF-LQC with water connections
Protect the waste water supply at both sides with the delivered hose clamps.
