Making the documents
29
Producing the documents
This section contains the procedures for making documents
automatically and manually.
Automatic operation (on-line mode)
Use this procedure when the 301 DFS is in the on-line mode.
1. Select the correct cover supply from the Control Panel of
the 301 DFS.
2. Program the host machine to deliver the copy sets to the
301 DFS.
3. Retrieve the bound documents from the Output Tray of the
301 DFS.
NOTE:
The entire binding process for each copy set takes
about two minutes from the time the copy set enters the
301 DFS until it is available as a bound document in the
Output Tray of the 301 DFS.
NOTE:
When the documents exit the 301 DFS, you can
handle them and browse through them. You should not,
however, allow them to lie open until the glue in the cover
spine has cooled and reached full strength. The
recommended cool-down time depends on the width of the
spine and the number of documents. Refer to the document
cool-down table in chapter 7, ”Technical data”.
NOTE:
Move the Document Guide to the left. This will
allow you to remove the documents without causing
damage to the covers.
NOTE:
When the copy set contains around 70 sheets or
more, it will stay in the Interface Module about 10 seconds
before starting the binding process. This will take most of
the air out from the set.
Summary of Contents for 301 DFS
