6
MaG aa aUtoMatic
PiSton PoSitioninG
MaG aa aUtoMatic MoUntinG SPecificationS
Install piston assembly into
piston housing. Be sure all
o-rings are properly lubricated
with MG75 Teflon based
lubricant provided with o-ring
repair kits.
Piston assembly must be
bottomed out in the piston
housing.
Lift the collet until it stops and
hold in an upright position while
inserting a 5/16" wrench onto
the collet.
Insert and tighten the collet
locknut using a second 5/16"
wrench and “wrench tighten”.
If properly assembled, bottom
of collet should be 3/16" from
the top of the piston assembly.
Piston Assembly
Piston Housing
Piston Assembly
Collet
Collet Locknut
3/16"
1.750
1/4" O.D. TUBE X
1/8"NPT FITTING
CYLINDER AIR
SIDE PORT
AIR FAN
ADJUSTMENT
1/4"NPT(F)
FAN AIR INLET
1/4"NPT(F)
ATOMIZING AIR INLET
1/2" DIA HOLE
FOR GUN MOUNTING ROD
SET SCREW FOR ROD MOUNT OR
SINGLE BOLT ADAPTER MOUNT
1/4"NPT(F) FLUID
INLET TYPICAL
BOTH SIDES
5 9/16"
.966
1.826
2.700
.704
1.470
3.158
2.306
.402
.402
8-32 X 3/16"
DEEP TYPICAL 8 PLACES
PISTON VENT AND FLUID
BY-PASS WEEP PORT
PLate MoUntinG SPecificationS
1.201
1.282
1.375
MaG aa aUtoMatic HoSe HooK-UPS
SPRAY GUN
SPRAY GUN
CYLINDER
AIR SOLENOID
(3-WAY)
ATOMIZING AIR
REGULATOR
PLUG
FLUID SUPPLY
FILTER
CYLINDER AIR
ATOMIZING AI
R
CYLINDER
AIR SOLENOID
(3-WAY)
FLUID SUPPLY
FILTER
AT
OMIZING AIR
CYLINDER AIR
FAN AIR
FAN AIR
REGULATOR
ATOMIZING AIR
REGULATOR
FLUID RETURN
FLUID RETURN
GROUND
GROUND
Hose Hook-Up with atomizing/fan air coMBined
Hose Hook-Up with atomizing/fan air SePaRated
oPtionaL adaPteR
PLate MoUntS aRe
LiSted on PaGe 8
PTFE
