Field
Description
Local ID Type
Only for Phase-1 (IKE) Parameters
Select the local ID type.
Possible values:
•
:< P:= ! " P!"
•
$--
•
5@ $--
•
"*!" !-:-7 "
Local ID Value
Only for Phase-1 (IKE) Parameters
Enter the ID of your device.
For Authentication Method =
! :$
,
:$
or
3$<.
the Use Subject Name from certi-
ficate option is displayed.
When you enable the Use Subject Name from certificate op-
tion, the first alternative subject name indicated in the certificate
is used, or, if none is specified, the subject name of the certific-
ate is used.
Note: If you use certificates for authentication and your certific-
ate contains alternative subject names (see
Certificates
on
page 124), you must make sure your device selects the first al-
ternative subject name by default. Make sure you and your peer
both use the same name, i.e. that your local ID and the peer ID
your partner configures for you are identical.
Alive Check
During communication between two IPSec peers, one of the peers may become unavail-
able, e.g. due to routing problems or a reboot. However, this can only be detected when
the end of the lifetime of the security connection is reached. Up until this point the data
packets are lost. These are various methods of performing an alive check to prevent this
happening. In the Alive Check field you can specify whether a method should be used to
check the availability of a peer.
Two methods are available: Heartbeats and Dead Peer Detection.
The menu Advanced Settings consists of the following fields:
23 VPN
bintec elmeg GmbH
486
elmeg hybird 120 / hybird 130
