Field
Description
IP Compression
Select whether compression is to be activated before data en-
cryption. If data is compressed effectively, this can result in
higher performance and a lower volume of data to be trans-
ferred. In the case of fast lines or data that cannot be com-
pressed, you are advised against using this option as the per-
formance can be significantly affected by the increased effort
during compression.
The function is enabled with
;
.
The function is disabled by default.
Alive Check
Select whether and how IPSec heartbeats are used.
A bintec elmeg IPSec heartbeat is implemented to determine
whether or not a Security Association (SA) is still valid. This
function sends and receives signals every 5 seconds, depend-
ing on the configuration. If these signals are not received after
20 seconds, the SA is discarded as invalid.
Possible values:
•
: 3
(default value): Automatic detection of whether
the remote terminal is a bintec elmeg device. If it is,
($
;- U#.3
(for a remote terminal with bintec
elmeg) or
36
(for a remote terminal without bintec el-
meg) is set.
•
36
: Your device sends and expects no heartbeat. Set
this option if you use devices from other manufacturers.
•
($;- #.3 <
: Your device expects a
heartbeat from the peer but does not send one itself.
•
: Your device expects no heartbeat from the peer, but
sends one itself.
•
($;- U#.3
: Your device expects a
heartbeat from the peer and sends one itself.
Propagate PMTU
Select whether the PMTU (Path Maximum Transfer Unit) is to
be propagated during phase 2.
The function is enabled with
;
.
The function is enabled by default.
bintec elmeg GmbH
23 VPN
elmeg hybird 120 / hybird 130
493
