Motorized/Smart Zebra Shades
Instruction Manual
P3
BINTRONIC ENTERPRISE CO., LTD
No.62, Bengong 5th Rd., Gangshan Dist., Kaohsiung City 82059, Taiwan (R.O.C.)
Email: sales@bintronic.com
This instruction manual version is v1.0.
All Rights Reserved.
Copyright © 2022 Bintronic Enterprise
STEP-1
STEP-1
Press [SET] + [DOWN] keys until Motor makes a twitch;
then, press [SET] + [DOWN] keys again until Motor makes
another twitch, indicating that the setting mode of Light
Filtering Position is activated.
STEP-1
STEP-2
Press [UP] or [DOWN] key to move the Zebra Shade to a pre-determined position,
to be set as the Light Filtering Position.
back
the Motor will make a twitch
press [SET] + [DOWN] twice
When the Motor makes a
twitch, the Zebra Shade will
move upwards and
downwards at the same time
as a response.
STEP-1
STEP-3
When the pre-determined position is reached, press the
[STOP] key once to stop the movement; press either of
the keys [UPWARD LIGHT FILTERING] or [DOWN-
WARD LIGHT FILTERING] + [SET] to confirm; the
setting is completed when the Motor makes a twitch.
When the Motor makes a
twitch, the Zebra Shade will
move upwards and
downwards at the same time
as a response.
The motor makes a twitch.
press [STOP]
press 1 of the keys + [SET]
When all procedures are done, the Light
Filtering Position setting is completed, too.
1-3 Setting of Light Filtering Position
Do not press any key within 5 seconds; and then press
[STOP] to return to the full light transmittance mode
from any position.
1-4 Setting of Auto Light Filtering
Tap to fine tune. Press for 2 seconds,
and it will move continuously.
press [STOP] after 5 seconds, the Zebra Shade
will close automatically and return to the full
light transmittance mode
When entering the Light Filtering
Position setting mode, the mode
will be deactivated if no keys are
pressed within 5 seconds. Plus,
previous setting will not be
recorded. Please go back to
STEP-1 and reset it.
reach to the
Light Filtering
Position
CAUTION
Setting Completed