Motorized/Smart Zebra Shades
Instruction Manual
P6
BINTRONIC ENTERPRISE CO., LTD
No.62, Bengong 5th Rd., Gangshan Dist., Kaohsiung City 82059, Taiwan (R.O.C.)
Email: sales@bintronic.com
This instruction manual version is v1.0.
All Rights Reserved.
Copyright © 2022 Bintronic Enterprise
6-1 Battery Replacement
6-2 Product Specifications
6-3 Quick Setting Index
6-4 Instructions for using Remote Control Holder
Completed.
1
2
With flat side (po) of the Battery
facing upwards, making sure that the
Battery is latched up by two spring plates,
insert Battery in a slanted angle to enter it
into the Battery Holder.
flat side (po)
latched up by two
spring plates
Battery:
CR2450 3V (One-time type lithium battery)
Dimensions:
L 13CM, W 4.8CM, H 1.1CM
Standby Current:
<1uA
Modulation Method:
OOK
Encoding Method:
Internally-burnt fixed coding
Transmission Frequency:
433.92MHz
Antenna Type:
on board, Gain=0 dbi
Weight (including battery):
66g
Upper-Limit Setting:
[SET]+ [UP]
Lower-Limit Setting:
[SET]+ [DOWN]
Setting of Light Filtering Position:
[SET]+ [DOWN] *twice
Setting of Auto Light Filtering:
do not press any key for 5 seconds, and then press [STOP]
Add another Remote Control:
(Original Remote Control) [SET] + [STOP], (Remote Control 2) [STOP]
Alter direction of Zebra Shade movement:
[SET] + [STOP], [UP] + [STOP] + [DOWN] (reverse direction), [UP] + [STOP] + [DOWN] (forward direction)
Clear off Password:
[UP] + [STOP] + [DOWN] + either [UPWARD LIGHT FILTERING] or [DOWNWARD LIGHT FILTERING] key, [UP] + [DOWN].
Vertical Holder
Wall-mount Holder
Open-up support plate on
the back for the use as a
vertical holder.
open up
Apply the provided double-face
adhesive tape on the back of
Holder and stick it onto the
desired position on the wall, as
a wall-mounted holder.
Apply the adhesive tape
stick it onto the
desired position
