Bio-Medical Research Tummy Lift Instruction Manual Download

Page: 9 / 30

Description of your

ACTIVATOR

’s symbols:

There are a number of technical markings on your

ACTIVATOR

. These can be explained as

follows:

The

ACTIVATOR

and belt are manufactured for Bio-Medical Research Ltd, Parkmore Business

Park West, Galway, Ireland.

The

ACTIVATOR

requires 1 x 3.6 volt (NiMH) DC battery pack DC is indicated by the symbol:

The Output Frequency indicates the number of pulses per second transmitted by the

ACTIVATOR

. This is measured in hertz, which is indicated by “Hz”.

Output (RMSA) means the maximum output root mean square current for each channel.

Output (RMSV) means the maximum output root mean square voltage for each channel.

This symbol means “Attention, consult the accompanying documents”.

This symbol means type BF applied parts.

This symbol on your

ACTIVATOR

is to indicate conformity to the requirements of the

Medical Device Directive (93/ 42/EEC). 0366 is the number of the notified body
(VDE).

Conforms to UL STD 60601-1.
Certified to CAN/CSA.
STD C22.2 NO 601.1

SN stands for ‘serial number’. Inside the box, on the back of the

ACTIVATOR

is the serial

number specific to this

ACTIVATOR

. The letter preceding the number indicates the year of

manufacture, where “P” denotes 2010, “Q” denotes 2011 etc.

The belt’s batch number is represented on the belt packaging by the number corresponding
with the LOT symbol.

Rated Outputs – Voltage/Currents: E:10

Parameter

500Ω

1KΩ

1K5Ω

Output RMSV

7.35V

13.1V

15.5V

Output RMSA

14.7mA

13.1mA

10.3mA

Output Frequency

50-70Hz

DC Component: Approx.

0 C

Positive Pulse Width:

200-315µs

Negative Pulse Width:

200-315µs

Interphase Interval:

100 µs

Attention:

The

ACTIVATOR

can deliver currents in excess of 2mA/cm2 if used with incorrect GelPads.

At the end of the product lifecycle, do not throw this product into the normal household
garbage, but bring it to a collection point for the recycling of electronic equipment.

Some product materials can be re-used if you bring them to a recycling point. By
re-using some parts or raw materials from used products you make an important
contribution to the protection of the environment. Please contact your local authorities
if you need more information about collection points in your area.

Waste Electrical and Electronic Equipment can have potentially harmful effects on
the environment. Incorrect disposal can cause harmful toxins to build up in the air,
water and soil and can be harmful to human health.

Belt Materials:

Outer material: 100% Nylon, Binding: 82% Nylon, 18% Elastane, Hook & Loop: 100%
Nylon, Foam: 100% Polyurethane

Caring for your

ACTIVATOR

Your

ACTIVATOR

should not be allowed to get wet or be left in excessive sunlight. It may

be cleaned regularly using a soft cloth, lightly dampened in soapy water. Do not allow
the interior of the

ACTIVATOR

to become wet. Do not use detergents, alcohol, spray

aerosols or strong solvents on your

ACTIVATOR

Access to the interior of the

ACTIVATOR

is not required for maintenance purposes.

If your

ACTIVATOR

is damaged, you should not use it but should return it to

BMR

or your

local distributor for replacement or repair. Repairs, service and modifications may not
be carried out by anyone other than qualified service personnel authorized by

BMR

IMPORTANT

Under no circumstance should anything other than the correct type of

batteries (rechargeable batteries 3.6V NiMH) be used with your

ACTIVATOR

. These can

be purchased from the Careline.

Disposing of the GelPads and batteries

Used GelPads and batteries must never be disposed of in a fire but in accordance with
national or state laws governing the disposal of such items.

NOTES

The signal gradually increases to a peak intensity level at the start of the contraction

phase (i.e. ramp up) and gradually decreases to nothing at the start of the relaxation phase
(i.e. ramp down). When the

symbol is flashing, the stimulus is significantly reduced.

Beauty Series Accessories:

You can purchase all accessories at www.bmrbeautyseries.com. Under no circumstances
should anything other than

BMR LIFT

accessories be used with your

ACTIVATOR FOR LIFT

(Type 390) or charger. Any others may not be compatible with the product and could
degrade the minimum safety levels.

BMR TUMMY LIFT

Garment (E:10)

BMR TUMMY LIFT

GelPads:

•1 large GelPad (Type 706 or 709)
•2 small GelPads (Type 707 or 710)

BMR BOTTOM LIFT

Garment (E:30)

BMR BOTTOM LIFT

GelPads:

•4 large GelPads (Type 716)

BMR ARM LIFT

Garments (E:60)

BMR ARM LIFT

GelPads:

•4 small GelPads (Type 715)

Belt Extender
Battery pack

(3.6V, NiMH)

Battery Charger (EU - 2504-0303)
Battery Charger (US/Japan - 2504-0302)

Charger complies to IEC 60950 and UL 1950, Input: nominal voltage 100-240V, frequency
50-60Hz, current 90mA. Output: 6V / 550mA. Do not use any other chargers or any other
power supplies.

Product Type:

391

Intended use:

Muscle stimulator

Classification:

Internally powered equipment, Class II charger, Type BF applied parts.

Waveform:

Symmetrical bi-phasic square waveform when measured into a resistive load.

Environmental Specifications:

Operating:

Temperature Range: 0 - 35°C (32 - 95°F)
Humidity:

20 - 65 % RH