12
PlateNum: The running position of this step is optional for 1-6 boards.
Wait Time
（
min
）
: This step stands time, unit minutes, the upper limit is set 99.
Blend time
（
min
）
: the oscillation time of this step is set per unit minute with an upper limit of 99.
Blendmode: Vertical
，
Horizontal/Vertical modes are optional.
BlendGear: low, medium and high three are optional.
Temp
（
℃
）
: You can choose whether this step needs heating or not. The heating temperature can be
set freely.
MagneticTime: the number of magnetic magnets used with an upper limit of 99.
Volume
（
ul
）
: corresponding to the volume of liquid in the corresponding hole of the 96-well deep
hole plate, according to which the stirring sleeve will adjust the mixing distance of shock or
magnetic shock, and at the same time calculate the time of magnetic absorption at this position once.
Preheat
：
Heat in advance to ensure that the heating step can be carried out directly into the preset
temperature.
Top: Moves the selected step to the first step of the program.
Up: Moves the selected step to the top run position.
Downl: Moves the selected step to the next run location.
Bottom: Moves the selected step to the last step of the program.
Add: Add a run step below the selected step.
Edit: Make the above steps editable.
Save: normally, it is in grey display state. Click modify and change the running steps to clickable
state. Click to save the latest modification.
Delete: Deletes the selected step.
Return: Returns the previous section.
3.3.3 Introduction of built-in programs
Figure 3-8
Open "Program Run", select the first program "Nucleic Acid Extract", click "Select", and enter the
interface as shown in Figure 3-9.
