10
Factory Default
8.1 Performing a Factory Default
FIRST:
Please remove the lock off the door & place it on a table or desk.
NOTE: If you are trying to troubleshoot an issue with the BioBolt,
reconnect the power cable and test your lock. If the lock now works, the
problem was likely a cable connection issue. If this does not solve the
problem with the lock, disconnect the power cable and move on to the
next steps.
NOTE: It is recommended to use new AA batteries when testing the unit to
assure power is not the problem.
NEXT: Find the “Reset” sticker near where the connector cable goes into
the back lock body. There is a hole where the cable meets the circuit
board. Inside that hole you will find a small round “reset button” much like
a reset button on a router.
NEXT: Press & hold down the little “Reset” button with a small screwdriver
or paperclip.
NEXT: While holding the “Reset” button down, use your other hand to
slide the scanner cover up.
NOTE: After about 10-15 seconds you will hear a single beep indicating
the lock has been reset.
HINT: To confirm, slide the cover down then up & enter the default Master
Code 11111111. It will activate the motor to retract the deadbolt.
For more troubleshooting information visit:
http://www.fingerprintdoorlocks.com/help/
5) If you are hearing a Beep sound:
1-Beep = Successful Action (scanned finger, entered code etc..)
3-Beeps = Unsuccessful Action
3-Sets of 2 Beeps = The User ID# is already in use
Rapid beeping sound when the cover is lifted = Low Battery Warning
Rapid beeping sound when enrolling a new user = Out of Memory
BioBolt
®
evo3 Biometric Deadbolt
http://www.bioboltlock.com | Intelligent Biometric Controls, Inc. | v1.1
