BioBolt
®
evo3 Biometric Deadbolt
http://www.bioboltlock.com | Intelligent Biometric Controls, Inc. | v1.1
This manual assumes that the door has been prepared for a US
standard deadbolt lock. If the door has not been prepared, please
refer to the documentation that came with the door cutting hardware.
With the bolt extended (A), locate the stamped
“UP” in the top back corner of the bolt (B).
Insert the bolt into the prepared hole on the
door being sure that the “UP” arrow is pointed
upwards. Now, ensure that the cross slot (C) is
centered vertically (x-axis) of the hole.
B
C
A
Using the supplied screws, attach the bolt to
the door. Attach the bolt to the door loosely at
first. You can fasten it down tighter after you
have tested the unit and it is functioning
properly.
NOTE: If the screws are tightened down too
much it puts pressure on the tail piece and
then on the motor, which will cause the bolt to
move slowly.
Installation
12
11.1 Preparing a Standard US Preparation for Lock Installation
