5
5. LOCKING MOUNTING ASSEMBLY DETAIL
The lower mounting ring (which is
part of the dispos
al
) has 3 tabs that
grab the mounting ring ramp.
(A)
points to the Upper Mount Ring.
(B)
is the tab that slides up onto the
“Ramp”.
(C)
is the "Ear" that is used to help
rotate the Lower Mount Ring.
Use a screwdriver for leverage if
needed.
Lift and turn the Lower
Mount Ring counter clock-
wise until all three mount
tabs lock over the Ridges
(F) on the slide-up Ramps
(D) of the Upper Mount
Ring.
As the Lower Mount Ring is turned counter
clockwise each tab slides up onto the Upper
Mount Ring Ramp
(E)
and locks in position over
the Ridges
(F)
.
Use a screwdriver or hammer for leverage if
needed.
If a dispos
al
needs to be removed, tapping on
the Ear clockwise with a hammer will easily
loosen the Lower Mount Ring.
Attach dispos
al
onto the Upper Mount Ring by aligning the three mount tabs on the Lower Mount
Ring with the slide-up Ramps on the Upper Mount Ring and rotating counter clockwise. See Below.
A
C
B
D
F
E
3. DISHWASHER CONNECTION PREPARATION
KNOCK
OUT PLUG
WOOD OR
METAL DOWEL
If you are utilizing a dishwasher, complete the following procedure.
Using a blunt instrument (steel punch or wooden dowel), knock out entire plug. Do not use
a screwdriver or sharp instrument. (When knockout plug falls into dispo
sal
, you may remove
it or grind it up when the dispos
al
is used. This will not damage the dispos
al
in any way, but
it may take some time to grind).
A.
Connect the waste elbow to the dispos
al
by sliding the flange
against the rubber gasket on the elbow and tightening the screws
into the dispos
al
(see 4A). Then connect bottom of the elbow by
tightening the slip nut (see 4B).
If using a straight pipe, it must
have a lip similar to the one on the elbow. Remove the gasket
from the elbow and install it on the straight pipe with the flat end
of the gasket facing toward the dispos
al
discharge opening.
B.
If you are connecting to a dishwasher, return to section 2B. If not,
make sure all plumbing connections are tight and in accordance
with all plumbing codes and ordinances. Run water and check for
leaks.
C.
Depress the wings on the spring clamp to remove it from the
rubber sleeve. Slip the spring clamp over the smooth side of the
elbow and slide it towards the lipped side of the elbow. (see 4C).
Insert the waste elbow into the rubber sleeve so the elbow lip fits
into the groove located inside the rubber sleeve. Position the
spring clamp over the rubber sleeve and secure (see 4D). If
using
a straight pipe, use one with a lip matching the lip on the
elbow
supplied with the dispos
al
.
D.
If you are connecting to a dishwasher, return to section 2B. If not,
make sure all plumbing connections are tight and in accordance
with all plumbing codes and ordinances. Run water and check for
leaks.
RUBBER
GASKET
SPRING
CLAMP
RING
P-Trap
4B
4A
4C
FOR THE MODEL (
GDI series
)
4. ATTACHING DISCHARGE ELBOW
FOR ALL MODELS
4D
GDI Series (AC motor)
