6
THIS DISPOS
AL
IS EQUIPPED WITH A
GROUNDED PLUG-IN POWER CORD.
B. This appliance must be grounded. In the event of a
malfunction or breakdown, grounding provides a path
of least resistance for electric current to reduce the
risk of electric shock. This appliance is equipped with
a cord having an equipment-grounding conductor and
a grounding plug. The plug must be plugged into an
appropriate outlet that is properly installed and
grounded in accordance with all local codes and
ordinances. If the supply cord is damaged it must be
replaced by the manufacturer, its service agent or
similarly qualified person in order to avoid a hazard.
Removing an attached power cord or plug voids
the warranty.
GROUNDING INSTRUCTIONS
A.
Connect the dispos
al
to appropriate household
current only.
7. ELECTRICAL CONNECTIONS
WARNING:
IMPROPER CONNECTION OF THE EQUIPMENT-GROUNDING CONDUCTOR CAN RESULT IN A
RISK OF ELECTRIC SHOCK. CHECK WITH A QUALIFIED ELECTRICIAN OR SERVICEMAN IF YOU ARE IN DOUBT
AS TO WHETHER THE APPLIANCE IS PROPERLY GROUNDED. DO NOT MODIFY THE PLUG PROVIDED WITH THE
APPLIANCE IF IT WILL NOT FIT THE OUTLET. HAVE A PROPER OUTLET INSTALLED BY A QUALIFIED ELECTRICIAN.
The receptacle to which this appliance is
connected must be controlled by a switch.
Having Problems? Don't go back to the store.
Call us
(0086) 571 8795 7615
for assistance.
M-F 8:00am-5:00pm PST English &
Chinse
FOR
GARBAGE DISPOSAL
S NOT EQUIPPED
WITH A GROUNDED PLUG-IN POWER CORD.
GROUNDING:
This dispos
al
must be connected to a
grounded, metal, permanent wiring system; or an
equipment-grounding conductor must be run with the
circuit
conductors
and
connected
to
the
equipment-grounding terminal or lead on the dispos
al
.
An acceptable motor control switch with a marked off
position shall be provided at the time of installation
to disconnect the dispos
al
from all ungrounded
supply conductors. The switch shall be mounted in
sight of the dispos
al
or in sight of the sink opening for
the dispos
al
.
WARNING: Electric Shock
Turn off power before installing or servicing dispos
al
.
All wiring must comply with local electrical codes.
Do not connect electrical current at main breaker panel
until adequate ground is established. Inadequate
connection of the ground wire can result in a risk of electric
shock. Consult with a certified electrician or tradesman if
there is any doubt whether the disposer in
inadequately
grounded.
Your
dispos
al
must
be
adequately grounded.
PERMANENT WIRE INSTALLATION INSTRUCTIONS
6. DISCHARGE ELBOW & DISHWASHER CONNECTIONS
A. Connect bottom of the elbow by tightening
the slip nut (see
6A
).
If you are connecting to a dishwasher,
see B. If not, make sure all plumbing
connections are tight and in accordance
with all plumbing codes and ordinances.
Run water and check for leaks.
B.
Connect dishwasher hose (
6B
) using a
hose clamp. Make sure all plumbing
connections are tight and in accordance
with all plumbing codes and ordinances.
Run water and check for leaks.
6A
*
AIR GAP
*Air gap may not be required for all
installations. Check local plumbing
codes.
DISPOS
AL
RUBBER
HOSE
DISHWASHER
HOSE
DRAIN
6B
