declaration of conformity
emissions
Manufacturer’s declaration electromagnetic emissions
The Gait Trainer III Treadmill is intended for use in the electromagnetic environment specified below.
The customer or the user of the Gait Trainer III Treadmill should assure that it is used in such an
environment
emission test
compliance
electromagnetic environment
RF emissions CISPR 11
Group 1
The Gait Trainer III Treadmill generates
RF energy only for its internal functions.
Therefore, its RF emission is very low and is not
likely to cause any interference in nearby
electronic equipment
RF emissions CISPR 11
Class A
The Gait Trainer III Treadmill is suitable for use
in all establishments other than domestic and
those directly connected to the public
low-voltage power supply network supplying
buildings used for domestic purposes.
Harmonic distortion
Class A
EN 61000-3-2
Voltage fluctuations
Complies
and flickerEN 61000-3-3
Immunity
Manufacturer’s declaration electromagnetic immunity
The Gait Trainer III Treadmill is intended for use in the electromagnetic environment specified below.
The customer or the user of the Gait Trainer III Treadmill should assure that it is used in such an
environment.
Immunity test
Iec 60601-1-2
Iec 60601-1-2
electromagnetic
test level
compliance level
environment – guidance
Electrostatic discharge
± 6 kV contact
Contact ± 6 kV
Floor should be wood,
(ESD)
± 8 kV air
Air ± 8 kV
concrete or ceramic tiles.
IEC 61000-4-2
If floor is covered with
synthetic material, the
relative humidity should
be at least 30%
Electrical fast
± 2 kV for power lines
Power ± 2 kV
Mains power quality
transients/burst
± 1 kV for
Signal ± 1 kV
should be that of a
IEC 61000-4-4
input/output lines
typical commercial or
hospital environment
Surge
± 1 kV differential mode
± 1 kV diff. mode
Mains power quality
IEC 61000-4-5
± 2 kV common mode
± 2 kV com. mode
should be that of a
typical commercial or
hospital environment
CONTENTS
ELECTROMAGNETIC COMPATIBILITY
— 10-2 —
Summary of Contents for 950-284
