Biodom 27 d. o. o.
T: +386 8 205 10 86
info@biodom27.si
OIC Hrpelje 4 a, 6240 Kozina
F: +386 5 662 67 57
www.biodom27.si
24
7.0 PELLET QUALITY
This furnace is meant for combusting A1 or A2 quality pellets.
Due to the market being overloaded with pellet products, make sure you choose the cleanest product possible.
Ensure that you use quality pellets (compact, low dust contents, A1 quality).
Ask your manufacturer about the best quality pellets (diameter 6 mm and up to 30 mm in length).
Correct furnace operation is dependent on the type and quality of the pellets. Different products may
produce different heat intensity.
THE MANUFACTURER ACCEPTS NO LIABLITY FOR SUBPAR QUALITY PELLETS OR IMPROPER FURNACE
OPERATION DUE TO INCORRECT PELLET SELECTION.
7.1 PELLET STORAGE
Pellets need to be stored in a dry and warm storage space. Cold and moist pellets (5 °C) lower the thermic
power of the fuel and eventually demand additional furnace cleaning.
DO NOT STORE PELLETS NEAR YOUR FURNACE.
Store the pellets at least 2 m away from the furnace. Handle
with care, do not break the pellets.
WARNING:
Throwing sawdust or smaller broken pellets into the funnel-shaped part of the furnace may block pellet (fuel)
feed.
Such instances may cause electric motor overload or damage on the reducer (part of the electric motor).
Clean any remaining pellets found at the bottom of the pellet tank or the feed screw by using a vacuum
cleaner. Insert the vacuum cleaner tube through the opening of the pellet grille and clean.
