3.0µ 4.0
1.0µ 1.5µ 2.0µ
L
L
L
L
µL
Performing a Test
4) Twist off and set aside the protective cover of the disposable lancet.
5) Replace the depth adjustable cap.
6) Choose a depth of penetration by rotating the top portion of the depth adjustable cap until the
setting depth matches the window. Settings are based on skin type
” “ for soft or thin skin;
” “ for average skin;
” “ for thick or calloused skin.
7) Hold the hub in one hand and pull on the plunger in the other hand. The device will be cocked.
Release the plunger, it will automatically move back to its original position near the hub.
5
1) Wash and dry your hands. Take one strip from the vial. Close the vial cap immediately.
2) Insert the strip into the strip port on meter with the indication symbol facing up. Push the strip in
until it clicks and stops. The meter will automatically detect code number.
3) When you see the flashing blood drop, hold the lancing device to side of your fingertip and press
the release button.
4) The Meter only needs a tiny blood sample. Please take a minimum of 1.0µL to do the test on
blood glucose monitoring system. Blood sample size above 3.0µL might contaminate the meter.
Not enough blood (<1.0µL) might cause inaccurate result.
5) Touch and hold the drop to the edge of sample entry until you hear a " beep " and the view
window is totally filled with blood. If the view window is not totally filled with blood, the test might
not start. Then discard the test strip and repeat the test with a new test strip.
6) You will see the countdown mode on the screen. After 5 seconds, the test result appears. For
more information, please check your User Manual
for details.
7) Remove the test strip from meter. Please follow the local regulation and discard the used strip
properly.
For more information on how to use your meter and understand your test results,
please see the User Manual.
BIONIME CORPORATION
694, Renhua Road, Dali Dist,
Taichung City 412, Taiwan
Tel: 886-4-24951268 Fax: 886-4-24952568
Email: info@bionime.com
Website: www.bionime.com
4
6
7
8
1
2
9
10
11
8) Pull off the depth adjustable cap. Without touching the used disposable lancet, stick the lancet
tip into the protective cover.
9) Hold the release button in one hand and pull on the plunger in the other hand will safely eject
the used disposable lancet.
10) Discard the used disposable lancet into an appropriate puncture-proof or biohazard container.
11) Replace the depth adjustable cap after finishing the test.
Bionime GmbH
Tramstrasse 16
9442 Berneck
Switzerland
5
5
7
Sample Size Example
4
4
1) Hold the adjustable cap in one hand and hold the hub in the other hand. Bend the cap towards
the down side. When a gap appears between the cap and hub, pull them off in opposite
directions.
2) Pull off the depth adjustable cap.
3) Insert a new disposable lancet firmly into lancet carrier.
Preparing the Lancing Device
1
2
3
6
1
2
3
101-3GM700-010
EN
Rev
. Date : May/2012
