0REPARATIONFORMEASUREMENT
- Rest for 5 minutes before taking a measurement
- Sit at a table with your arm supported and legs uncrossed
- Avoid all movement and muscle tension
- Breathe normally and do not speak
- Wait at least 1 minute between consecutive measurements
- AM & PM measurements should be taken 10-12 hours apart
To start your measurement, see section 3.6 Measuring Your Blood Pressure.
Once the Protocol is complete, after the 7 days, you can view your average. See section 3.9B Recalling Memory
in 7D Mode.
)-0/24!.4
)TISCRITICALTHATUSERSFOLLOWTHEMEASUREMENTPROTOCOLCAREFULLYTOENSURERELIABLEDATAFOR
diagnosis.
1. Take 2 measurements in the morning (ideally after going to the bathroom and before eating
or drinking).
4AKEMEASUREMENTSINTHEEVENINGAPPROXIMATELYHOURSAFTERTHEMORNINGMEASUREMENTS
and ideally not immediately after the evening meal.
2EPEATTHESEMEASUREMENTSPERDAYFORDAYSCONSECUTIVELY
./4%-ISSINGMEASUREMENTSWILLCAUSE%22TOAPPEARONTHEDISPLAY#ONTINUEWITHTHE
SEQUENCEOFMEASUREMENTSANDDISCUSSWITHYOURDOCTORWHENYOUREVIEWTHEDATA
./4%4HEMACHINEONLYRECOGNIZES!-AND0-READINGSEACHDAY)TDOESNOTEXCLUDE!-
AND0-MEASUREMENTSONLYAFEWHOURSAPART%ACHMEASUREMENTHASATIMESTAMP
$ISCARDANYMEASUREMENTSTHATWERENOTATLEASTHOURSAPARTWITHYOURDOCTOR
3.5 General Mode
In General Mode, a user can take blood pressure measurements outside of the Protocol
Software (7D Mode).
1. When the monitor is OFF, press the
SET
button, a small triangle will appear above 7D
Mode on the monitor. Press the “
+
” or “
-
“ buttons to switch between 7D Mode and
General Mode. Press
SET
to confirm.
2. Next, select the user. Press
SET
to confirm, then press
34!2434/0
button to power
off the monitor.
3. To start your measurement, see section 3.6 Measuring Your Blood Pressure.
-EASURING9OUR"LOOD0RESSURE
!FTERTHECUFFHASBEENAPPROPRIATELYPOSITIONEDANDTHECORRECTMODEHASBEENSELECTEDTHEMEASUREMENTCANBEGIN
1. Press the
34!2434/0
button until all the symbols appear on the screen. Right after “
vWILLmASHONTHESCREENSEESECTIONTOUSETHE"LUETOOTHFUNCTION/2PRESSTHE
34!24
34/0
button again to continue with the measurement. You will hear 2 short beeps and after “
vWILLmASHFORSECONDS4HEPUMPTHENBEGINSTOINmATETHECUFF4HEINCREASINGPRESSUREIN
the cuff is shown on the display.
7D mode General mode
