ZERO
MAX
1. Press S button to turn ON the Scaler.
2. Tip Working mode:
1. Press P button to turn ON the Polisher.
2. Tip Working mode:
3. Select scaler function:
3. Select polisher function:
4. Water regulation:
4. Water regulation:
5. Foot Pedal Control:
5. Foot Pedal Control:
6. Cleaning:
6. Cleaning:
Comprehensive cleaning function:
Turn off the polisher by holding down
P
for
a few seconds. Now the cleaning function
can be started by pressing first
C
and then
P
. Water or disinfectant (40 sec) and air (40
sec) cleans the handpiece. The cleaning cycle
stops automatically after
80 seconds.
The polisher is
activated
when the foot control
pedal is pressed down. The polishing power is
regulated with the foot pedal from:
left/ZERO = WaterJet (only water and air) middle
to right/MAX =
60 or 100%
depending on which
working mode is chosen on the control panel.
Problems? See Section 6 Troubleshooting in the owner’s guide.
Air purge quick cleaning function:
To prevent clogging; air purge the handpiece
after each polisher treatment by pressing
C
.
or
With every push on the
P
button, the
function toggles from:
1. Normal polishing
2. Air cleaning (only air)
3. WaterJet cleaning (only water and air)
60 %
100 %
With the water control set at highest flow
setting depress the foot pedal and slowly
reduce the water flow with the water control
wheel on the side of the powder container
until the powder starts to accumulate
on the surface as a white spot. Increase
the water flow until the spot disappears.
The polisher is now balanced for optimal
performance.
Ultrasonic Scaler QuickStart Guide:
Scaler
Polisher
Comprehensive cleaning function:
The cleaning function can be started by
pressing
C
. Water or disinfectant cleans the
water line and handpiece. The cleaning cycle
stops automatically after
80 seconds
.
The unit is in
standby
mode when the
power cord is connected and the green
LED is illuminated.
With every push of the
S
button, the
function toggles from:
Scaling with water
Dry mode: scaling without water
Irrigation mode: just water, no scaling
Choose the working mode
or
or
100 %
70 %
40 %
7. Push the S button for 3 seconds to
turn the scaler OFF.
7. Push the P button for 3 seconds to
turn the scaler OFF.
Depress the foot control pedal in the leftmost
position and adjust the water flow with the
control ring
on the scaler handpiece until
the water is dripping.
The scaler is
activated
when the foot
control pedal is pressed down. The power
is regulated from left/ZERO to right/MAX
within the chosen working mode.
In ZERO
position
there are two functions:
a) irrigation with no scaling power: hold
the footpedal down.
b) diagnostic light: press the footpedal
once.
This working mode
cannot be activated
when using the polisher.
Recommended
Optional
OFF
ON
1
1
2
2
3
4
3
4
Choose the correct working mode that is
marked on the base of each tip by pressing
the corresponding working mode button on
the keypad:
