Biostar T-Series
TForce4 SLI
User’s Manual
12
Chapter 3: NVIDIA SLI Function
3.1
R
EQUIREMENTS
Only Windows XP supports SLI (Dual Video) function.
Two identical SLI-ready graphics cards that are NVIDIA certified.
The graphics card driver should support NVIDIA SLI technology.
The power supply unit must provide at least the minimum power required by the
system, or the system will be unstable.
3.2
P
LACING THE
SLI-NF4
S
ELECTOR
C
ARD
There is a pre-installed SLI-NF4 selector card on the motherboard. The default
setting is Normal Mode, only supports single graphics card.
To use two graphics cards, firstly, you have to set the selector card to SLI Mode,
to support dual video cards.
Step 1: Push the retention clips outward to release SLI-NF4 selector card.
Step 2: Pull the selector card out of the slot.
Step 3: Invert the selector card and insert the edge labeled “SLI MODE”.
Step 4: Push down the selector card until the retention clips snap into place.
Notice:
Make sure to insert the card into the slot completely.
○
2
pull out the
selector card
○
1
about 45
O
degree
lift.
○
1
Insert the card with a
degree about 45
0
.
○
2
Push the selector card
downward.
