Biotage Extrahera Classic, Installation And Safety

5

Installation

34. Place the pipette tip waste bin for used pipette tips below 

the 

WASTE

 position on the working area.

35. Place the solvent rack with five new, empty solvent reservoirs 

in position 

5 

on the working area. Ensure that the solvent 

feeder is pulled out into the correct position; see Figure 11.

Figure 11.

 The solvent feeder in position.

Connections

Figure 12

1

2

3

4

5

.

 Solvent connections located on the back wall inside the system.

Port

Label

Connect

1

S1

The S1 solvent inlet line (right port) and the 

S1 solvent feeder tube (left port).

2

S2

The S2 solvent inlet line (right port) and the 

S2 solvent feeder tube (left port).

3

S3

The S3 solvent inlet line (right port) and the 

S3 solvent feeder tube (left port).

4

S4

The S4 solvent inlet line (right port) and the 

S4 solvent feeder tube (left port).

5

S5

The S5 solvent inlet line (right port) and the 

S5 solvent feeder tube (left port).

Figure 13

6

7

8

.

 Waste connections located on the back wall inside the system.

Port

Label

Connect

6

Waste outlet tube between the waste valve 

and the waste reservoir.

7 + 8

Waste tube between the waste valve and 

the extraction waste collector.

Figure 14

10

9

12

11

.

 Connections located on the right hand side at the rear of the 

system.

Port

Label

Connect

9

T4A-250VAC Electrical supply: 100 to 240 V~, 50/60 Hz, 

300 VA

Fuses: T4A (2 required)

10

LAN

Network. Optional.

11

N

2

The gas applied to the samples through 

the pressure head. See the gas supply 

requirements in the technical specification 

on page 6.

12

AIR

The gas used for the movement of the 

pressure head. See the gas supply 

requirements in the technical specification 

on page 6. 

Upgrade the Biotage

®

 Extrahera

™

 Software

Please refer to the instructions delivered with the new software.