Bird Site Analyzer
34
Measure the Match of the Component
1. Connect the Site Analyzer to the component being
tested as follows:
y
ANTENNA –
(if used) Connect the Phase Stable
Cable directly to the coaxial connector of the
antenna. There should be no other transmission
lines or jumpers connected.
y
OTHER COMPONENTS –
(Including Jumpers,
Transmission Lines, Lightning Protectors, and RF
Filters) Connect the Phase Stable Cable to one end
of the component. Connect the Calibration
Combination Load to the other end of the
component.
2. Wait at least 10 seconds for the sweep to update.
When you have a trace on the screen, you can do any of
the following:
•
Hold the trace (refer to Measurement Hold, page
35)
•
Add markers to the trace (refer to Markers, page
79)
•
Save the trace (refer to Save Trace, page 92)
•
Summary of Contents for SITE ANALYZER SA-1700EX
