Measure Match Mode
35
Interpreting the Measurement
The graph below shows a typical Match Measurement
for an antenna system.
1. Parts of the sweep below the limit line are better
than the limit.
2. Antennas and filters should be below the limit line
for the entire band, and above the limit line
outside the band.
3. Other components should be flat and below the
limit line across the entire band.
Measurement Hold
You must be in either Measure Match mode or Fault
Location mode to hold a trace.
The hold feature stops updating the display at the end
of the current sweep. Press the Hold soft key to hold
the displayed trace and press the Run soft key (the
same key) to resume taking measurements. A mea-
surement is being held when there is a lock icon in the
Antenna
Resonant Band
Limit Line
at –14 dB
Markers
Summary of Contents for SITE ANALYZER SA-1700EX
