45
Using RS422(VISCA) / RS485 (PELCO P/D)
You can use the RS422/485 port connect to optional controllers, such as joystick control keyboard, control PC
station, to operate the camera.
To perform pan/tilt and zoom operations using the joystick of the control keyboard, and to perform the Preset
operation using the control buttons.
An application software that supports this unit is needed if you use PC station.
RS422 (VISCA) connection
1.
On the base DIP switch:
•
Set for RS422 control.
•
Set the Baud Rate on the DIP switch to the same Baud Rate as the keyboard you are using.
•
Set the specific address for the controlled camera.
2.
If you want to have the camera address to be automatically assigned by VISCA controller, set the camera DIP
switch address to 0.
3.
Reboot the camera by turning it Off and On after the DIP switch has been set.
4.
Use the included RJ45 to RS422 cable. The controller must be VISCA compatible.
5.
The camera supports Daisy Chain connection of up to 7 cameras.
HDMI Video Signal
SDI Video Signal
Remote Control Signal
(RS422 (VISCA)
or RS485 (Pelco P/D))
IR Remote Controller
