5. Place removable finger lift with saw guard assembly (Item No. A211MS-AL) on the saw guide bar (Item No.
116-13) and fasten in place with finger lift fastener knob (Item No. 211Q).
5
WIRING MOTOR
a. Interchange of motor current is made in motor outlet box. Leads are properly marked. Changing
instructions are on motor plate or motor box outlet box.
b. All cutters are wired 220 volts unless otherwise specified. Be sure motor specifications (voltage, cycle,
phase) match power supply line. Be sure line voltage is up to specification.
c. Connect leads to machine in a manner that will be approved by local electrical inspectors.
d. We recommend no less than No. 12 Ga. wire. If the leads are too light, machine may not have sufficient
cutting power and/or speed.
e. The V-belt is packed loose in machine to prevent deformation, and must be installed on pulleys at time of
wiring motor.
f. The BIRO Manufacturing Company is not responsible for permanent wiring, connection or installations.
NOTE TO OWNER AND ELECTRICIAN: IF THIS MACHINE IS NOT CORD
AND PLUG CONNECTED TO THE ELECTRICAL SUPPLY SOURCE, THEN
IT SHOULD BE EQUIPPED WITH, OR CONNECTED TO, A LOCKABLE,
MANUALLY OPERATED DISCONNECT SWITCH (OSHA 1010.147).
SHARP SAW BLADE. HANDLE WITH EXTREME CAUTION.
7. The stationary platter (Item No. A10163-1) is placed on top of the base structure and held in place by two
push-pull hold down rods (Item No. 10212W), located at the rear of the base.
8. The sliding meat carriage assembly (Item No. A10155) is installed by turning the movable stop assembly
(Item No. A200) clockwise. After the carriage assembly is in the channel for operation, turn the movable
stop counterclockwise to lock.
6. Placing blade on cutter: Hang upper wheel assembly (Item No. A10003U335) on the hinge bracket
(Item No. S71-0). Lift the nylon filler (Item No. 177). Hang blade on the upper wheel and hold with right
hand. With the left hand force the back of the blade between the front blade cleaners (Item No. 131), located
below the nylon filler. Lower the nylon filler and insert the back of the blade in the upper saw guide (Item
No. 602B). The blade has already dropped over the lower wheel. With right hand force the back of the
blade between the rear blade cleaners. The blade is now ready to be tightened. Press down on the ratchet
arm (Item No. 10-1) located at the rear of the base structure. Turn the upper wheel slowly by hand to ensure
proper tracking of the saw blade on the wheels. Tighten to proper tension. When the tension gauge (Item
No.197), located at the bottom rear of the head becomes tight laterally the blade is at proper tension.
9. Post
SAFETY TIPS
wall chart within easy view of operator. Keep Manual available to operator.
10. Machine
MUST
be properly grounded. Use qualified electrician to install according to building codes.
KEEP HANDS CLEAR OF SHARP MOVING BAND TYPE SAW BLADE