NOTICE TO OWNERS AND OPERATORS
Warnings related to possible damage are indicated by:
OR
1
This Manual contains a number of safe practices in the SAFETY TIP section. Additional warnings are
placed throughout the Manual. Warnings related to your personal safety are indicated by:
BIRO’s products are designed to process food products safely and efficiently. Unless the operator is
properly trained and supervised, there is the possibility of a serious injury. It is the responsibility of the owner to
assure that this machine is used properly and safely, strictly following the instructions contained in this Manual
and any requirements of local law.
No one should use or service this machine without proper training and supervision. All operators should
be thoroughly familiar with the procedures contained in this Manual. Even so BIRO cannot anticipate every
circumstance or environment in which its products will be used. You, the owner and operator, must remain alert
to the hazards posed by the function of this equipment - particularly the SHARP MOVING BAND TYPE SAW
BLADE. No on under eighteen (18) years of age should operate this equipment. If you are uncertain about a
particular task, ask your supervisor.
BIRO also has provided a wall chart to be posted near the equipment. If any warning label, wall chart, or
Manual becomes misplaced, damaged, or illegible, please contact your nearest Distributor or BIRO directly for
a replacement.
Remember, however, this Manual or the warning labels do not replace the need to be alert and to use
common sense when using this equipment.
This Manual applies to machines with serial number 9105 and higher, except where noted
.
“The descriptions and illustrations contained in this manual are not binding.
The manufacturer reserves the right to introduce any modification without
updating the manual.”
- NOTE -
“A copy of this manual is included with each MODEL 44SSFH
FIXED HEAD POWER MEAT SAW.”
Summary of Contents for 44SSFH
