17
DO’s
DON’Ts
• Always keep knife & plate as matched set.
• Always keep the knife & plate sharp.
• Always install the knife & plate in correct
sequence, knife 1st, then plate.
• Always inspect the plates making sure all holes
are clear - that there are no cracks.
• Always keep knives & plates lubricated in storage
and when starting machine.
• Always check for straightness by laying the knife
on the plate before inserting in machine.
• Always use coolant when sharpening plates.
• Never, never mix different knives to different plates.
• Never, never over tighten the bowl retaining ring
on the machine.
• Never, never hit the plate against anything to
clean the holes.
• Never, never run the grinder without product.
Product is a natural lubricant. Heat can build up so
fast that cold product could crack the plate.
• Never, never throw the knives & plates.
GRINDER KNIVES & PLATES
SAFETY
Always inspect parts for cracks, heat fractures, discoloring. Never run on parts that have these defects.
Always use O.S.H.A. lockout tagout procedures when changing knives and plates!
Always wear gloves when handling knives and plates.
Never run plates below minimum thickness.
Customer is responsible for safety, installation, and operation of equipment. It is the responsibility of the user to
comply with all O.S.H.A. or A.P.H.I.S. regulations.
IMPORTANT!
USE KNIFE AND PLATE TOGETHER
Always use the same knife and plate together. If one
has gradually worn away from perfect level, the other
will have worn with it. As a result they may still be
used together. If however, one is matched with a
different member which is ground true, the set will
certainly not turn out a good product. In addition, such
practice will probably break the new member.
Available Grinder knives and plates for Model Mini-22
Knife, Size 22, Standard Disposable
MC22-17
Plate, Size 22, ⅛” (3,5mm) diameter holes
MC22-18-125
Plate, Size 22,
5
/
32
” (4,0mm) diameter holes
MC22-18-156
Plate, Size 22,
3
/
16
” (5,0mm) diameter holes
MC22-18-187
Plate, Size 22, ⅜” (9,0mm) diameter holes
MC22-18-375
Summary of Contents for MINI-22
