CLEANING
ROTATING DRUM
TO AVOID PERSONAL INJURY
ALWAYS
Turn Off, Unplug From Power Source and Perform Lockout/Tagout Procedure to This
Machine
BEFORE
Cleaning or Servicing.
ONLY
Use Recommended Cleaning Equipment, Materials and Procedures.
NEVER
Spray Water or Other Liquid Substances Directly at Motor, Power Switch or any Other
Electrical Components.
ALWAYS
Thoroughly Clean Equipment at Least Daily.
DO NOT
Use Harsh Chemicals, Scouring Pads or Cleansers. Ordinary Liquid Detergent for
Manual Dish Washing or Pot/Pan Washing Will Not Harm the Machine. Dish Machine
Chemicals Will Cause Brown Stains, as will Chlorine Bleach and Similar Products if Allowed
to Stand in or on the Machine for Any Length of Time.
CLEANING THE BIRO VACUUM TUMBLER:
1. Turn “OFF”, unplug machine from power source, and perform lockout/tagout procedures.
2. The drum, drum lid, and gasket can be removed and washed in utensil sink. Be sure to flush the vacuum
valve on drum with warm soapy water and rinse with clean water thoroughly. The drum, drum lid, and
gasket should be sanitized with an appropriate sanitizer approved by your local Health Dept. All parts should
be air dried before reassembly and storage.
3. The exterior of the tumbler base and drum can be pressure washed with the same type soap solution followed
by a rinse water wiping.
4. If food stains are not removed, use a product such as “Bon Ami” or “Soft Scrub”. Be sure to scrub with the
grain of the Stainless Steel with a soft cloth or sponge.
5. Streaks or water spots can usually be removed with a solution of vinegar and water.
4
Summary of Contents for VTS-100
Page 17: ...15 CONTROL PANEL REAR VIEW ...
Page 23: ...120 VAC WIRING DIAGRAM 21 ...
Page 24: ...220 VAC WIRING DIAGRAM 22 ...
Page 26: ... NOTES 24 ...