1. Name of Components
2. Pre-Operation Checks
Caution !
DO NOT USE THIS STACKER AT ALL IF REPAIRS ARE REQUIRED OR IF YOU SUSPECT A MALFUNCTION
Perform the Pre-Operation checks before operating everyday.
1. Any damage, distortion or crack in post
2. Any damage, distortion or crack in carriage and forks
3. Smooth movement of front and rear wheels
4. Any oil leak from hydraulic line or cylinder
5. Any damage, kink or crack in chain
6. Check if brake works properly
7. Any natural lowering
8. Fastening of bolts and nuts
3. Operation
1. Lifting
① Put the fork of the unit into the center of the load
② Fork will rise by pumping the pedal. Lift up the
fork up to required height.
Caution !
* DO NOT lift up the load or anything above the rated capacity.
* DO NOT lift the load only at the tip of the forks. Lift up the load within loading diagram capacity
2. Lowering
① Fork will lower by pulling the lowering lever.
② Release the lever when the fork is lowered down to
required height.
Caution !
* DO NOT lower the fork too fast. Or it may result in the falling of the load.
* DO NOT pull the lever when moving.
- 2 -
Handle
Carriage
Fork
Lowering
Lever
Pumping
Pedal
Lift Cylinder
Lowering
Cable
Brake
Handle
Carriage
Fork
Handle
Lowering
Lever
Quick
Lifting
Handle
Pumping
Pedal
Brake Pedal
Pumping
Pedal
Quick Lifting
Cable
Lift Cylinder
Brake Pedal
Carriage
Fork
Lowering
Lever
Lift Cylinder
Lowering
Cable