3. Moving (Maneuvering)
① Hold handle and move unit carefully.
Caution !
* DO NOT move or turn around with load kept at a high position.
* DO NOT pull the Lowering Lever when moving
4. Quick Lifting Device
( applicable only with Quick Lifting Device installed model )
① Check if the Lowering lever is in closed position.
② Press the cut off part of the Qucik Lifting Handle
in and make sure it is engaged securely to the roll pin.
And then rotate the handle clockwise
③ When Quick Lifting Device is not used, make
certain handle is off the roll pin (disengaged)
Caution !
* DO NOT use Quick Lifting Device when load is on the fork.
* When Quick Lifting Device is not used, make certain the handle is off the roll pin (disengaged).
If kept engaged, the handle will rotate and can be dangerous when lowering lift.
5. Brake
① To Lock -
Step down the lever of the caster to lock the brake on the wheel
② To Release -
Pull up the brake lever by toe.
Caution !
* Make certain to set the brake whenever the lift is not moving.
6. Adjusting the Fork Width
① Lift up the top end of fork and slide the fork.
4. Circuit Diagram
【 Hydraulic Circuit 】
Standard Model
With Quick Lifting Device
- 3 -
On
Pulley shaft
Roll
Pin
Handle
Handle
Spring
Snap Ring
Off
Loc
Release
Relief
Relief Valve
Lift
Cylinder
Lift
Cylinder
Pump
Cylinder
Pump
Cylinder
Lowering
Valve
Lowering
Valve
Ris
Rise
UP
UP
Down
Down