10
Figure 15 Right Outrigger Stopped Mid-Travel LED Indicators
Figure 16 Left Outrigger Stopped Mid-Travel LED Indicators
Figure 17 Outrigger Obstruction LED Indicators
Right Outrigger Stopped Mid-Travel
– If the operator
releases the UP or DOWN button with the right outrigger
in between it’s fully retracted or fully deployed positions,
the right 3 red LEDs will stop scrolling and fl ash. Continue
to depress the UP or DOWN button to ensure the right
outrigger is either fully retracted or fully extended.
Left Outrigger Stopped Mid-Travel
– If the operator
releases the UP or DOWN button with the left outrigger
in between it’s fully retracted or fully deployed positions,
the left 3 red LEDs will stop scrolling and fl ash. Continue
to depress the UP or DOWN button to ensure the left
outrigger is either fully retracted or fully extended.
Outrigger Obstruction
– If either outrigger encounters
a pallet or fl oor obstruction which stops the outrigger’s
movement, all 6 red LEDs will fl ash (3 right LEDs followed
by 3 left LEDs). The LEDs will continue to fl ash until the
operator reverses the outrigger’s direction. CAREFULLY
remove the obstruction or reposition the UniLift to allow the
outriggers to rotate as required. For additional information
refer to the “OPERATING INSTRUCTIONS – Stacker
Mode/Pallet Obstruction” section of this manual.
Battery Charger LEDs
– The battery charger has 2 LEDs to indicate the charger’s status. The left CHARGER POWER LED will illuminate when
the charger is plugged into AC power with an extension cord. The right CHARGING/CHARGED LED is dual color and will glow yellow while the
batteries are charging and green when the batteries are fully charged. Always ensure the key switch is turned to the OFF position while charging
the batteries. Discharged batteries will typically require four (4) to six (6) hours to completely recharge.
Before using the UniLift for the fi rst time, plug an extension cord into the charger’s power cord and allow the batteries to completely charge. The
charger’s CHARGING/CHARGED will glow green when the batteries are fully charged. Disconnect the extension cord and push the plug back
into the recess. The UniLift is now ready for use. Before using the UniLift, make sure you are familiar with the SAFETY INSTRUCTIONS, the
OPERATING INSTRUCTIONS and are TRAINED. Only trained and authorized personnel shall be permitted to operate a UniLift.
