Italia Star Com Due S.R.L.
www.italiastar.ro
info@italiastar.ro
004/021.433.03.27
113
Assembly 1. Insert valve seat (7) with the ball seat surface
facing up into the housing (8). 2. Insert O-ring (6) into the
housing (8). 3. Insert filter cartridge (3). 4. Place thin seal (5) on
threaded section of housing (8). 5. Place thick seal (4) on top of
thin seal (5). 6. Slide pressure spring (2) onto housing cover pin
(2). 7. Screw on housing cover (1) and tighten by hand.
8.4 Cleaning Airless spray gun – Rinse Airless spray gun with an
appropriate cleaning agent. – Clean tip thoroughly with appropriate
cleaning agent so that no coating material residue remains. – Thoroughly
clean the outside of the Airless spray gun.
Intake filter in Airless spray gun Dismounting (fig. 17) 1. Pull protective
guard (1) forward vigorously. 2. Screw handle (2) out of the gun housing.
Remove intake filter (3). 3. Intake filter congested or defective – replace.
Mounting 1. Place intake filter (3) with the long cone into the gun
housing. 2. Screw handle (2) into the gun housing and tight en. 3. Snap in
protective guard (1).
9. Remedy in case of faults 9.1 Gasoline engine
9.2 Electric Motor
