MANUTENZIONE PERIODICA DELL’ALBERO E DEGLI STRUMENTI
DI METALLO FLESSIBILI
1.-Per realizzare i lavori di manutenzione in trasmissione e strumenti di metallo prima scoleggare il motore.
2.-In tutte le operazioni di manutenzione saranno usati dei pezzi originali.
3. Da verificare l’usura dello strumento di metallo controllando il diametro esterno e la lunghezza dello
strumento di metallo. Sostituire la struttura o la copertura quando il diametro o la lunghezza nel piu piccolo
e’ inferiore rispetto a quella menzionata nel tabella in base al modello.
4.-ungere l’albero a ogni 100 ore di lavoro.
Una modalita’ d’ungere l’albero e’ di prendere un po di grasso nella mano e con la mano chiusa con grasso
toccare la lunghezza dell’albero, lasciando sull’albero uno strato sottile di grasso sull’intera lunghezza
dell’albero. La quantita’ raccomandata e’ di 25 g per metro. Non ungere in eccesso, questo potrebbe
determinare che il grasso entri nel camino. Non pulire l’albero con solvente. Il grasso raccomandato e’
STABURAGS N-4 del marchio KLUBER LUBRICATION, o altro equivalente con le seguenti caratteristiche:
Capitolo.5
Punto di drenaggio s/ DIN
Limite di temperatura
Temperatura massima su durata corta di tempo
Inserimentodi lavoro s/ DIN 51804 (0.1mm)
Consistenza s/ DIN 51818
Fattore di velocita( ndm)
>220
30-130
180
260
2/3
500.000
5.- Quando la lunghezza dell’albero non e’ uguale a quella del tubo di gomma (+-10 mm) e’ necessario che si
sistemi prima di produrrsi un danno piu grande.
6.- Ad ogni 300 ore di lavoro e’ raccomandato di cambiare il lubrificante dello strumento di metallo. 6.1
DEPOSITO
Quando il motore AVMU non e’ stato usato tempi lunghi questo dovrebbe essere sempre depositato in zone
pulite, asciutte e protette.
6.2 TRASPORTO
Quando trasporttate con dei veicoli, essere sicuri che il motore e’ protetto contro lo scivolamento,
ribaltimento e i colpi.
.
SCHEMI ELETTRICI
Italia Star Com Due S.R.L.
www.italiastar.ro
info@italiastar.ro
004/021.433.03.27
18