background image

6  

w w w. a s t o n i z e . c o m   7 8 0 . 7 0 1 . 5 1 1 2

Troubleshooting

Reduce Spray or No Spray  

Possible Causes

1.  

Water tank may be empty.

2.

 

Tank may not be seated completely.

3.

 

Pump may have lost prime.

4.

 

Debris filter on base is clogged.

DirtLifter® PowerBrush does not turn  

Possible Causes

1.  

The belt is off or broken.

2.

 

The unit is in the upright position.

3.

 

Circuit breaker on machine may have tripped.

Cleaner not picking up solution  

Possible Causes

1.  

Tanks may not be seated properly.

2.

 

Clean water tank is empty.

3.

 

Dirty water tank has picked up the maximum amount of dirty  

 

water the red float door has closed.

4.

 

Red float “door” in the tank may have closed as a result of  

 

bumping an object or moving machine back and forth too  

 quickly.

5.

 

Front nozzle of machine is clogged.

6.

 

Upper body filter is clogged.

Remedies  

1.  

Fill clean tank with hot tap water.

2.

 

Turn power OFF (0). Remove and reseat tank.

3.

 

Turn power OFF (0) and then back ON (I). Wait one minute,

 

then depress trigger.

4.

 

Use hand to remove debris.

Remedies  

1.  

Turn power OFF ( O ) and unplug unit from outlet. Follow

 

instructions on page 14.

2.

 

TBrushes only rotate when unit is reclined using the

 

detent pedal.

3.

 

Turn the machine OFF ( O ) and unplug from outlet. Check

 

to see if foreign object is caught in brush roll. Remove

 

object. Plug machine in to reset circuit breaker.

Remedies  

1.  

Pick up both the clean and dirty water tanks and reseat

 

them so they fit snuggly on the unit.

2.

 

Check fluid levels in clean water tank and refill if necessary.

3.

 

Empty dirty water tank. Refill clean water tank with water   

 

and formula. Place both tanks back onto unit.

4.

 

Turn the machine OFF(0), allowing red float door to release 

into the open position,. Turn the unit back ON (I) to continue 

cleaning. Be sure your forward and backward strokes are 

completed at a slower pace.

5.

 

Use fingers to remove any debris from this area.

6.

 

Use fingers to remove any debris from this area.

 WARNING:

To reduce the risk of fire, electric shock, or injury,turn power OFF and disconnect plug from electrical outlet before performing 

maintenance or troubleshooting.

Other maintenance or service not included in the manual should be performed by an 

authorized service representative.
Thank you for choosing Astonize Carpet Cleaner Rental.

Please do not return this product to the store.

For any questions please call 780-701-5112 or visit Astonize.com.

Summary of Contents for BG10 10N2 Series







Reviews: