5
Fig.2
Fig.3
Fig.4
Fig.5
Fig.1
Fig.6
Assembling the Appliance
• Insert the handle into the aperture at the top of
the body aligning the notch on the tube with the
rear of the unit, and straighten the security collar
(Fig.1).
Changing the pads and plates on your product
• Make sure machine is not plugged in before
fitting pads.
• Note the orientationof the drive hubs (Fig.2).
• Place the required Hook and loop - plate or
brushplate over the hub and rotate until the
shape lines up (fig.3)
• Press the plate down to clip into place (Fig.4).
• Always use two plates of the same type, i.e.
not 1 brush and 1 pad (Fig.5).
• Simply pull the plates off to remove and
change.
Adjust the handle to suit your height (Fig.6).
Summary of Contents for BGFS500
Page 9: ...9 Notes ...
Page 10: ...10 Notes ...
