(8) BISSELL BigGreen Commercial FMT Dual-Speed Floor Machine
BISSELL BigGreen Commercial FMT Dual-Speed Floor Machine (13)
3.2 Install / Change the Apron
If you’ve purchased more than one apron, you can easily
change aprons for different cleaning jobs.
• Lock the handle in the “up: position and tip the floor
machine back.
• If you’re changing the apron, give the brush a quick flip
counterclockwise to unlock and remove the brush.
• Remove the 3 knurled thumb nuts that hold the apron to
the machine chassis.
• Remove the existing apron.
• Align the new apron.
• Re-install the three bolts and tighten.
• Install a brush that is 2” smaller than the apron.
3.3 Attach the Power Cord
The triple-wire grounded power cord has been factory-
installed into the handle tube. A flexible rubber cable
connector (11) is used to secure the plug-in connections.
The floor machine ships with this connector mounted on the
cord coming out of the handle (10). Stretch the connector
and slip the male connector (9) (coming out of the motor
housing) through the connector hole and then into the
female connector.
Now, plug the end of the 50 foot cord into a grounded power
outlet. Squeeze the triggers on the handle and check for
power to the motor.
3.4 Brush or Pad Driver Installation
A brush or pad driver mounts onto your floor machine with
a “B” style Universal clutch plate.
Unplug the floor machine. Lock the machine handle in
the “up” position and tip the floor machine back onto the
handle.
Slide the brush or pad driver clutch plate (11) over the drive
plug (12).
Quickly spin the brush counter-clockwise to lock the brush
onto the drive plug.
Now, lower the machine back onto the brush. You’re ready
to go to work.
7.0 Machine Schematic Drawing
