16
Dirtlifter
®
PowerBru sh
®
does n ot tu rn .
Possible Causes
Remedies
The Brush Belt or Pum p Belt
Turn the m achine OFF and unplug from the
m ay be broken.
outlet. To check if a Brush Belt has broken,
you will need a flat head screwdriver.
Insert the blade end into the lower slot of the
Belt Access door to release the lower snap. If
necessary, insert the blade end into the upper
slot to release the upper snap. Exam ine for
belt breakage. The Brush Belt should be
visible, looped around the m otor shaft.
If it is broken or m issing, please refer to
Part Numbers and Desc riptions
on
page 17 before calling Consum er Services.
Com plete installation instructions will
accom pany the replacem ent belt.
Vacu u m n ot pickin g u p solu tion .
Possible Causes
Remedies
ReadyTools
™
switch m ay be at the
Set ReadyTools
™
switch to either Tools or
wrong setting for the cleaning job.
PreTreat or Floor Cleaning.
Drain cap m ay be m issing or not
Rem ove Tank-in-Tank,
™
loosen and
properly installed at back of
re-tighten Drain Cap.
Tank-in-Tank.
™
Tank-in-Tank
™
lid is not
Re-install lid; refer to
The Basic s
section.
properly installed.
Tank-in-Tank
™
is not properly seated.
Tank-in-Tank
™
m ust be firm ly seated to
function; rem ove and reseat Tank-in-Tank.
™
Poor tool position.
Adjust angle; apply m ore downward pressure.
( Hand held attachm ents only) .
Tank-in-Tank
™
has picked up
Empty Tank-in-Tank,
™
refer to
m axim um dirty water.
The Basic s
section.
Tr oubleshooting - continued
