12
www.BISSELL.com
1
Cleaning Machine After Use
Cleaning the Nozzle
First, fill the Clean Water
Tank with warm tap water
and then empty it all to
rinse. Then fill again with
warm tap water and return
the tank to the machine.
Twist cap back on tightly.
To flush and rinse the
machine:
Turn the machine
ON and press the Spray
Trigger for 15 seconds
while making back and
forth passes on a section of
carpet. Finally, release the
trigger and suck up
the water.
See page 11 to clean the
Dirty Water Tank from
the water that was just
sucked up. Empty the Clean
Water Tank and let dry
before storing. Wipe your
machine’s exterior with a
soft cloth.
2
1
3
4
If pet hair or debris
become clogged in
the nozzle, it can be
cleaned out of the
nozzle with the Nozzle
Clean Out Tool.
Turn OFF and unplug
the machine from the
grounded outlet.
Remove the nozzle from the Foot: flip the
Accessory Hose Door open and lift up on
the nozzle and Accessory Hose Door.
Return the nozzle back
to the Foot of the
machine. Line up the
three hooks on the
nozzle to the bottom of
the foot (see arrows for location).
Rotate the nozzle up and click into place.
Close the Accessory Hose Door.
Hold the nozzle and insert the Nozzle
Clean Out Tool into the thin slot at the
front of the nozzle where it touches the
floor. Clean until free of pet hair or debris.
WARNING
To reduce the risk of fi re, electric shock or injury, turn power OFF and disconnect plug from electrical
outlet before performing maintenance or troubleshooting.
Summary of Contents for PROHEAT 2X REVOLUTION 15484
Page 17: ...17 www BISSELL com Notes...
Page 35: ...17 www BISSELL com Notas...