BISSELL.ca
5
WARNING
When using the Deep Stain Tool, always keep the tool in direct contact with carpeting to avoid
over-spraying. Keep spray away from face. Failure to do so may result in personal injury.
Emptying the Stain Trapper Tool
(select models only)
1.
To empty the tool, rotate
the small tank on the bottom
to unlock it.
2.
Dump dirty water into a sink
or toilet and rinse the tank out
with clean water.
3.
Replace the tank by lining
up the locking teeth with their
mating slots (make sure the
two teeth that are closest
together are pointed toward
the brush). Turn the tank to
lock it into place.
Using the HydroRinse
TM
Tool
Emptying the Dirty Water Tank
We have additional tips for maintaining your machine at
support.BISSELL.ca
.
1.
When the Dirty Water Tank
reaches the “FULL” line it is
time to empty.
2.
Remove Dirty Water Tank
and carry to disposal area.
3.
Unlock by rotating the
handle up and over the back of
the tank.
WARNING
To reduce the risk of fire, electric shock or injury, turn power OFF before performing maintenance
or troubleshooting.
1.
Hold the hose and tool in an upright position with the
machine ON. Hold down the trigger for 30 seconds. Be
sure to empty the dirty water tank after use (see below).
2.
You can store tool on machine, as shown.
