10
Lift the Mixer Head. Place the Mixing Bowl onto the Mixer Stand and press
the Tilt button to lower the Mixer Head.
Controlling the Mixer Speed
To operate your mixer, always start mixing at the lowest speed. Make sure
the Low/Hi Speed Switch is in the “Low” position. Move the Speed
Selector from the OFF position to the desired speed. During operation,
you may change the speed of the mixer by selecting a new speed.
Ingredients may be added slowly during mixing. Stop the Mixer as needed
to scrape sides and bottom of Mixing Bowl with a plastic spatula.
Warning: Do not attempt to scrape sides or bottom of Mixing Bowl while
Mixer is in use.
Using the Power Burst Feature
For especially tough mixing tasks, use the Burst to quickly increase the
mixing speed to the maximum power level from any speed setting.
Upon release of the Burst button, the mixer will return to the original
speed setting.
Interrupting the Mixing Process
To stop your mixer during operation, move the speed control to the OFF
position.
Cleaning Your Hand Stand Mixer
Be sure the mixer is unplugged before cleaning. Do not immerse the
Mixer Motor Housing or plug in water or any other liquid. Press the Eject
button to detach any attachments from the Mixer. Wash in warm, soapy
water. Note: Always handle and store the beaters, whisk and dough
hooks carefully.
Lift up Mixer Head to remove and clean Mixing Bowl. Wipe the
Mixer, Stand and Turntable with a clean, damp cloth. Do not use abrasive
scouring pads or cleansers, as scratching can occur. Do not allow the
bowls, beaters, whisk or hooks to soak in water for extended periods
of time (several hours or overnight) to prevent damage to the
metal finish.
Using Your Hand Stand Mixer
9
Assembling the Hand Mixer to
the Stand
figure 1
figure 2
To attach the Hand Mixer, align the notches
located at the rear of the mixer with the
Tilting Mixer Head. Press downwards on the
front of the mixer until mixer clicks into
place (See figure 1). To raise the Tilting
Mixer Head, press the Tilt Button and lift the
mixer up by the handle. The mixer will
securely lock into the upward position. To
lower, press the Tilt Button and lower the
mixer into place (See figure 2).
To detach the Hand Mixer, press the Hand
Mixer Release Button and lift the mixer up
until detached. (See figure 3)
Inserting Attachments
1
Be sure the unit is unplugged
before inserting beaters, whisk or
dough hooks.
2
To insert Beaters or Dough Hooks,
the Mixer Head must be in the tilt-up
position (see fig. 2). Insert the beater
or dough hook with the hexagon collar
into the hexagon receptacle of the
mixing stand and the one with the
round collar into the round receptacle.
(See figure 4). Push each attachment
in as far as it will go; it will click as it
locks into place. If using the Whisk,
insert it into the hexagon hole.
3
Plug the mixer’s power cord into a 120
volt 60 Hz AC only outlet. Your mixer is
now ready to use.
Removing Attachments
1
Be sure your hand mixer is in the OFF
position and unplugged before
removing any attachments. Press the
Eject Button to easily remove beaters,
whisk or dough hooks (see figure 5).
figure 3
figure 5
figure 4
HSN_StandMixerManual_2 9/14/09 11:00 AM Page 9
