Magicians SOCD Cleaner V2
Section 5: Mechanical
INSTALLATION MANUAL & USER GUIDE
REV B
PAGE 6
Section 5: Mechanical
Mounting the Board
The dimensions of the Magicians SOCD Cleaner V2 is based off our previous SOCD cleaner
designs. This form factor offers simple and compact footprint for mounting within a controller
case. It features four mounting holes that are 0.122in (3.10mm) in diameter.
Always elevate the board a few cm away from the mounting
surface. Never directly mount board surface to a metal surface
(risk of shorting) or to a plastic surface (risk of ESD). It is
always best to use the mounting holes to prevent any damage.
Snap-In Adhesive PCB Feet
This mounting method uses four little feet that snap through the board’s mounting holes.
These feet then mount with double sided tape to a location in a controller. It is a common and
easy way to mount electronics inside of an arcade controller. We offer these for sale on our
website. Other reputable arcade parts retailers also offer them for sale.
Screw-In PCB Feet
This mounting method uses four little feet that screw through the board’s mounting holes.
These feet then mount with screws to a location in a controller. Screw mounting is common
on controllers where drilling is easy and practical, such as one made from wood. We offer
these for sale on our website. Other reputable arcade parts retailers also offer them for sale.
