Magicians SOCD Cleaner V2
Section 6: Electrical
INSTALLATION MANUAL & USER GUIDE
REV B
PAGE 7
Section 6: Electrical
Example Wiring Diagram
The below wiring diagram example shows the complete hookup using buttons. If using an
ODIN or LOKI, the OMNI and LED ports will be used. If using a pass-thru harness, it is not
necessary to connect the two-pin screw terminal.
Specifications
The table below shows an overview of the electrical system and its general specifications.
These will be explained later in more detail, but this is a good resource if you are already
familiar with the electrical system and just need some quick info.
Magicians SOCD Cleaner V2 – Electrical Specifications
Spec.
Value
Note
Operating Voltage
4V – 6V
Must be powered to work
properly. Not guaranteed to
work if outside this range
Max Current Draw
~120mA
When BLE is enabled.
~55mA
When BLE is disabled.
Signal Inputs
Common ground
Common voltage or rail will
not work.
Signal Outputs
Push-Pull
This means the signal
swings from 0V to ~3.3V.
Gauge Accepted on Screw
Terminal Block
18 – 30 AWG
Phillips or flat head
screwdriver depending on
terminal block availability.
For additional specifications, please contact us and we can update the table in this manual to
include your request.
