Magicians SOCD Cleaner V2
Section 6: Electrical
INSTALLATION MANUAL & USER GUIDE
REV B
PAGE 8
Sending Power to the Board
The Magicians SOCD Cleaner V2 has a few different ways it can be powered up. It can be
powered by the:
•
Power input screw terminal block
•
Pass-thru Harness Port
•
Micro USB port
Never try to power the board with higher voltage supplies that
are above 6VDC! For example, 12VDC, 48VDC, 120VAC, etc.
Over-voltage will damage the board!
The power input screw terminal block can theoretically handle
up to 15VDC but the internal regulator might overheat and
temporarily shut down to protect itself. It will also draw more
current if doing an advanced install, please take note of this.
When planning a scheme for input power, it is suggested to never apply voltage to more than
one port at a time. However, no harm will result if for example the USB port and the power
input screw terminal both have voltage applied to them. Internally, they are diode “OR’d”
which means that current will be drawn by whichever power source has the higher voltage.
Connector Map
1
Power Input Screw Terminal Block
5
Micro USB Port
2
Pass-thru Harness Port
6
OMNI Port
3
Button Input Screw Terminal Block
7
LED Port
4
Cleaned Output Port
1
5
2
3
4
6
7
