Rev. 1.00
- 38 -
SRP-275II
The position of the autocutter can be adjusted to another dimension using the GS (E command).
If paper longer than 68.3mm is used, the first receipt cannot be used when exchanging or reloading the roll
paper since it has been ejected.
When the black mark is preprinted in the range between the autocutting position to the position of 68.3mm:
Set the amount of the cutting position adjustment (a = 116 for the forward direction) with <Function 5> of
the GS ( E command).
D. Minimum distance of the black marks
If you use the receipt with a length other than 127mm, the distance between the black marks must be
more than 65mm.
3-3-4-2 Black mark paper: C Type(Without autocutter)
It shows the dimensions of the black mark when the receipt length is 127mm.
The black mark must be printed in one place in a receipt either on the right or left of the face or the reverse
side.
A. To avoid cutting preprinted material by mistake, this area must not be preprinted.
B. To avoid any false detection of the marks indicating the unprintable area, this area must not be preprinted.
Applying an end mark is also prohibited.