Rev. 3.02
- 11 -
SRP-350
2-2 Operation
2-2-1 Setting the DIP switches
The DIP switches are located on the bottom of the printer. The DIP switches are used to set the printer to perform various
functions. Follow these when changing DIP switches setting:
1. Turn the printer power switch off.
2. Remove the screw on the bottom of the printer and open the
bracket.
3. Flip the DIP switches using tweezers or another marrow-ended
tool. Switches are in when up and off when off down.
4. The new setting takes effect when you turn on the printer.
※
Note : Always change DIP switch settings only when the
printer is turned off. Change made with the power on
have no effect and then on again.
Figure 2-5 Setting the DIP switches
2-2-2 Setting the DIP switch (RS-232C Serial Interface)
• DIP Switch 1
SW
Function
ON
OFF
Default
1
Auto Line Feed
Always enabled
Always disabled
OFF
2 Reserved
-
-
OFF
3 Handshaking
XON/OFF
DTR/DSR OFF
4
Word length
7 bits
8 bits
OFF
5 Parity
check
Yes
No
OFF
6 Parity
selection
EVEN
ODD
OFF
7
ON
8
Baud rate selection
Refer to the Following Table 1
OFF
• DIP Switch 2
SW
Function
ON
OFF
Default
1
Code Page Selection
Refer to the Following Table 3
OFF
2
Internal bell control
Internal bell disable
Internal bell enable
OFF
3
Auto Cutter Selection
Disable
Enable
OFF
4
Code Page Selection
Refer to the Following Table 3
OFF
5
OFF
6
Select Print Density
Refer to the Following Table 2
OFF
7
Near End Sensor Status
Disable
Enable
OFF
8
Code Page Selection
Refer to the Following Table 3
OFF
Summary of Contents for SRP-350 PlusA
