EN
7
Data Hold and Backlight
To freeze the LCD meter reading, press the data hold button. The data hold button is located on the left side of the meter
(top button). While data hold is active, the HOLD display icon appears on the LCD. Press the data hold button again to
return to normal operation.
Note:
The HOLD feature will activate when the Backlight is turned on. Press the HOLD key again to exit Hold.
The backlight function illuminates the display and is used when the ambient light to too low to permit viewing of the
displayed readings. Press the HOLD) button for one second to turn the backlight on and press the button a second
time to turn the backlight off.
Manual Ranging
The meter turns on in the autoranging mode. Press the Range button to go to manual ranging. Each press of the range
button will step to the next range as indicated by the units and decimal point location. Press and hold the Range button for
two seconds to return to autoranging. Manual ranging does not function in the AC Current , Diode and Continuity check
functions
Battery Replacement
1. Remove the one rear Phillips head screw
2. Open the battery compart
3. Replace the Requires one (NEDA1604, 6F22 006P)
4. Re-assemble the meter
The rating for the test Probe is CAT III 1000V 10A
Exe_Notice_BIZ 780313.indd 7
15/05/2019 17:35
