GPH Plus Owner’s Manual 21
CG
LABEL 5
Use Channel 9
Channel Guard Values
For Channel 5
USER SELECTED CHANNEL GUARD
When the radio is being programmed with transmit and receive
frequencies for each channel, a receive Channel Guard value and a
transmit Channel Guard value can also be assigned to each channel. If
User Channel Guard Selection is enabled, the Channel Guard values
for any channel can be copied to another channel in the radio. The
CTCSS or CDCSS guard values will be copied.
For example, to use the Channel Guard values
of Channel 9 with the frequencies of Channel 5:
1. Slide Switches B and C down.
2. Turn the Channel Selector knob to Channel
5.
3. Press the
[9]
key on the keypad. The
display shows
CG
.
The radio will now operate on the
frequencies of Channel 5 with Channel 9
Channel Guard values. The display shows
the Channel Guard channel (9), and then
the selected channel (5).
4. Press the
[#]
key to display the Channel
Guard channel briefly. The display shows
the group number, followed by the Channel
Guard channel, and then the selected
channel.
5.
Press the
[0]
key
to reset all values to the
original programming, or press different
number keys (1–16) to select a different set
of Channel Guard values.
NOTE:
During Scan or Priority Scan, the
receiver does not use the user-
selected Channel Guard values.
However, user-selected Channel
Guard values are used by the
transmitter in Scan Mode.
CG
LABEL 9
Copy Channel Guard
Values from
Channel 9
1
2
3
4
5
6
7
8
9
0
*
#
CLR
FCN
PRI
ENT
Summary of Contents for GPH Plus
Page 1: ......
Page 35: ...34 RELM Wireless Corp NOTES ...
Page 36: ...GPH Plus Owner s Manual 35 NOTES ...
Page 37: ......