- 1 -
Introduction
The KAA0700 Cloning Cable offers radio users to ability to share
programmed information between KNG portable radios.
Operation
The Source radio is a radio programmed with the desired radio
frequencies and settings you wish to transfer to another radio of the
same frequency range.
In order to clone radio information the Source radio must have a menu
item programmed, via PC Radio Editor KAA0730, to allow cloning.
(Refer to the “Menus/Controls” section of the radio editor.)
The radio receiving the program is referred to as the Target.
Target radios can be programmed to block incoming cloning information
on a zone by zone basis.
KNG radios only allow one cloning option: Active Zone.
KNG-S radios allow for three cloning options: Active Zone, Zone-to-Zone
or Entire Radio.
Active Zone
- Copies the information in the Source radio’s active zone
to the Target radio’s active zone.
Zone-to-Zone
- Allows for selection of any zone in the source radio to
be copied into any non-blocked zone in the Target radio (functional on
KNG-S to KNG-S cloning only.)
Entire Radio
- Copies all non radio specific data from the Source radio
to the Target radio. Radio specific data includes P25 ID, serial number,
encryption keys and passwords. (functional on KNG-S to KNG-S cloning
only.)
