- 7 -
Legacy Radio Cloning
Information programmed in some older BK Radio models can be cloned
to KNG models.
Cloning compatible models include: DPHX5102X, GPH5102XP, DPHX-
CMD, GPH-CMD, DMH, GMH Plus and most GPH portable models.
NOTE: E-Series portables are not cloning compatible with KNG models.
NOTE: Earlier BK Radio models use the term “Group” instead of “Zone”.
ch 00
PRG
prog
PRG
clone
PRG
fail
PRG
-- -- id
Master
Switch
ch 01
Digital
Connect the KAA0701 Cloning Cable to
the side connector of the Source and
target radios and power up both radios.
On the KNG Target radio, select the zone
to receive the incoming information.
On the Legacy Source radio:
Select the source group/zone by
1.
pressing the [#] key and entering the
number of the desired zone.
Press and hold the master switch then
2.
press and hold the [FCN] key until the
display shows “- - - ID.”
Enter the password of the selected zone.
3.
The display shows “PRG CH 00.”
Press the [*] key on the Source radio.
4.
The display will flash “PROG” signifying
that the radio is ready to download its
program to the target.
Press the [FCN] key send the cloning
5.
information.
ch 00
PRG
prog
PRG
clone
PRG
fail
PRG
-- -- id
Master
Switch
ch 01
Digital
While sending information “CLONE” will be
displayed on the source radio.
If the cloning process fails or the target
radio’s zone is blocked form accepting
an incoming clone, A fail message will
appear on the Source radio.
To stop the ‘FAIL’ Mode, press [CLR], .
